10 Starting and Stopping Analysis
10.1 Making an Injecting and Starting an Analysis
111
GC-2014
Q Injection
10.1.3 Starting the analysis
Start an analysis program when the STATUS light is green.
Press the [START] key to start the temperature program, the time program, the pressure
program and the flow rate program.
Any pre-set programs execute prior to the start of the analysis programs.
Aspirate sample. Insert syringe until it
touches needle guide.
Push plunger to inject
sample.
At same time, press
[START] key of gas
chromatograph.
Promptly pull out
syringe.
WARNING
Wear protective goggles when handling samples.
To Next Page
Loading...
