Shimadzu GC-2014 - Specifying Clean up Parameters; Screen Description

7 Starting and Stopping the GC [SYSTEM]
7.2
7.
82
GC-2014
7.2Specifying Clean Up Parameters
7.2.1 Screen Description
Select [Clean Up] (PF menu) from the [SYSTEM] key main screen to display the clean up
parameter setup screen shown in Fig. 7.2.1. The parameters set for the clean up program
are set by including “Clean Up Para” as part of the GC start procedure.
Clean up should be performed to eliminate contamination before analysis.
Reform the clean up when the gas chromatograph has not been used for a while or if a new
column has been installed.
(a) DINJ (b) SPL
Fig. 7.2.1 Setting the clean up parameters