Shimadzu GC-2014 Instruction Manual

15 Optional Devices
15.5 Setting the CRG Parameters
210
GC-2014
15.5.2 Parameter list
COLUMN OVEN
VALVE Selection: On/Off, Default: Off
CRG Selection: Use/Not Use, Default: Not Use
When the CRG is connected to the column oven, the column oven temperature
control range is extended to -99.0 −+400.0 °C from (room temperature + 4 °C)−
+400.0 °C.
When using the CRG, set “VALVE” to “On” and “CRG” to “Use”.
When using valve control only, set “VALVE” to “On” and set “CRG” to “Not Use”.
INJ 2
VALVE Selection: On/Off, Default: Off
CRG Selection: Use/ Not Use, Default: Not Use
When the PTV is installed on INJ2, the injection port temperature control range is
extended to -99.0−+400.0 °C from 0.0−400.0 °C
When using the CRG, set “VALVE” to “On” and “CRG” to “Use”.
When using valve control only, set “VALVE” to “On” and set “CRG” to “Not Use”.
15.5.3 PF menu
PF menu Description
Reference
section
Next
Toggles the screen among AOC parameters → AUX temperature → AUX
APC → AUX AMC → CRG screens in this order.
――

Shimadzu GC-2014 Specifications

General

Type	Gas Chromatograph
Display	LCD
Maximum Heating Rate	120°C/min
Data Acquisition	Digital
Maximum Number of Detectors	4
Weight	Approx. 45 kg
Carrier Gas	Helium, Nitrogen, Hydrogen
Detector Options	FID, TCD, ECD, FPD
Injection Port	Split/Splitless, On-column
Gas Control	Electronic Flow Control (EFC)
Temperature Programming Rate	0.1 to 120 °C/min
Power Requirements	230 V AC, 50/60 Hz
Detector Temperature Range	Up to 400°C (depending on detector type)