Shimadzu GC-2014 Instruction Manual

15 Optional Devices
15.1 Auto Injector Parameters
198
GC-2014
15.1.4 AOC priority analysis
Select [Priority] (PF menu) from the AOC main screen to display the AOC priority sample
screen shown in Fig. 15.1.2.
The batch can only be interrupted when the AOC is operating.
Enter the sample injection No., and press [Set] (PF menu).
15.1.5 Parameter list
INJECTION SAMPLE
INJECTION SAMPLE NUMBER
Enter the sample vial No. designated for priority analysis.
・ When an auto sampler carousel is not in use,
Short rack No. 1−6
Long rack No. 1−12
・ When an auto sampler corousel is installed, No. 1−150 (maximum)
When an auto sampler carousel, the allowable vial No. range depends on the vial rack type
and the number of racks. A valve of 0 (default) indicates no priority sample.
Fig. 15.1.2 Priority analysis setup screen
NOTE

Shimadzu GC-2014 Specifications

General

Type	Gas Chromatograph
Display	LCD
Maximum Heating Rate	120°C/min
Data Acquisition	Digital
Maximum Number of Detectors	4
Weight	Approx. 45 kg
Carrier Gas	Helium, Nitrogen, Hydrogen
Detector Options	FID, TCD, ECD, FPD
Injection Port	Split/Splitless, On-column
Gas Control	Electronic Flow Control (EFC)
Temperature Programming Rate	0.1 to 120 °C/min
Power Requirements	230 V AC, 50/60 Hz
Detector Temperature Range	Up to 400°C (depending on detector type)