Shimadzu GC-2014 - Program Parameters

277
17 Printing
17.3
17.
GC-2014
17.3Program Parameters
Press [Print] from a time program or Pre-Run program to print the program as event No. or
parameter names.
This paragraph describes the parameter names and the display when a program stops.
Q Event No. (EVNT)
Refer to “17.4 Event No.”.
Q Temperature
Heated zone names from a temperature program are printed with the parameter names
shown below.
Column temperature : CITP
INJ1 : INJT
INJ2 : AITP
DET1 : DETT
DET2 : AUXT
AUX3 : TCDT
AUX4 : AX4T
AUX5 : AX5T
Q Detector range, polarity and current value
Detector range, polarity and the current value from a program are printed with the parameter
names shown below.
Range of DET #1 : D1RG
Range of DET #2 : D2RG
Range of DET #3 : D3RG
Range of DET #4 : D4RG
Polarity of DET #1 : D1PL
Polarity of DET #2 : D2PL
Polarity of DET #3 : D3PL
Polarity of DET #4 : D4PL
Current value of DET #1 : D1CR
Current value of DET #2 : D2CR
Current value of DET #3 : D3CR
Current value of DET #4 : D4CR