Shimadzu GC-2014 Instruction Manual

17 Printing
17.2 AOC commands
276
GC-2014
1: Without autosampler, short rack: 1−6
Without autosampler, long rack: 1−12
With autosampler: 1−150
Command names marked with “ * ” cannot be set on the GC screen.
SAMU Use of the sampler Not use: 0, Use: 1 Not use: 0
SUBU Use of the sub AOC Not use: 0, Use: 1 Not use: 0
BARC Bar Code Reader Not use: 0, Use: 1 Not use: 0
SPMD Distribution of sample for dual AOC 0−80
PAR1 Use of Same Param No: 0, Yes: 1 No: 0
*GLPM Setting of validation mode 0, 1 0
*GRPT Number of times of GLP sample discharge 1−99 50
*GVOL GLP sample discharge volume 1−80 20
*GPMP
Number of times of pumping after second
GLP
0−51
*ATSP Automatic stop function Off: 0, On: 1 On: 1
*ARSG Ready signal polarity Open: 0, Close: 1 Open: 0
TLET Rack Short: 0, Long: 1 Short: 0
TSEL Rack position while sampler is used 0−21
Command
name
Item Range Default
NOTE

Shimadzu GC-2014 Specifications

General

Type	Gas Chromatograph
Display	LCD
Maximum Heating Rate	120°C/min
Data Acquisition	Digital
Maximum Number of Detectors	4
Weight	Approx. 45 kg
Carrier Gas	Helium, Nitrogen, Hydrogen
Detector Options	FID, TCD, ECD, FPD
Injection Port	Split/Splitless, On-column
Gas Control	Electronic Flow Control (EFC)
Temperature Programming Rate	0.1 to 120 °C/min
Power Requirements	230 V AC, 50/60 Hz
Detector Temperature Range	Up to 400°C (depending on detector type)