Shimadzu GC-2014 Instruction Manual

16 Special Functions
16.2 Batch Schedule
224
GC-2014
16.2.8 Batch processing Setup example
Example Sample vials No. 1 to 3 are analyzed. The GC method file No. 2 is used. The
Chromatopac data processing file No. 0 is set to Ch 1.
A standard of known concentration is injected once.
Clean up is performed, but the slope test is not performed.
Screen display
1. Start vial No.: 1
Final vial No.: 3
2. GC file No.: FILE2
3. Data processing file No.:
Ch 1, FILE0
4. Number of injections: 1
Sample type: Standard
5. Slope test: Off
Clean up: On
6. The batch is set up.

Shimadzu GC-2014 Specifications

General

Type	Gas Chromatograph
Display	LCD
Maximum Heating Rate	120°C/min
Data Acquisition	Digital
Maximum Number of Detectors	4
Weight	Approx. 45 kg
Carrier Gas	Helium, Nitrogen, Hydrogen
Detector Options	FID, TCD, ECD, FPD
Injection Port	Split/Splitless, On-column
Gas Control	Electronic Flow Control (EFC)
Temperature Programming Rate	0.1 to 120 °C/min
Power Requirements	230 V AC, 50/60 Hz
Detector Temperature Range	Up to 400°C (depending on detector type)