Shimadzu GC-2014 Instruction Manual

18 Error Messages
18.1 Error Messages
300
GC-2014
18.1.8 Optional device error (AOC-20i/s)
One of these messages appears when an error has occurred in the AOC-20i auto injector or
AOC-20s auto sampler.
For details, refer to the AOC-20i/s User’s Manual.
Code Message CS
6001 AOC1 rack error No
6002 AOC1 syringe error No
6003 AOC1 plunger error No
6004 AOC1 can not start No
6005 AOC1 RAM initialized No
6006 AOC1 ROM error No
6007 AOC1 CH2 command error No
6008 AOC1 sample vial is not set No
6009 AOC1 RAM error No
6010 AOC1 installation error No
6011 AOC1 CH1 error No
6012 AOC1 CH2 error No
6013 AOC1 waste vial is not set No
6014 AOC-20s rotating error No
6015 AOC-20s exp. and ctrl. error No
6016 AOC-20s up/down error No
6017 AOC-20s can not start No
6018 AOC-20s vial setting error No
6019 AOC-20s vial returning error No
6020 AOC-20s holding error No
6021 AOC-20s sample vial removed No
6022 AOC-20s vial is not set No
6023 AOC2 rack error No
6024 AOC2 syringe error No
6025 AOC2 plunger error No
6026 AOC2 can not start No
6027 AOC2 RAM initialized No
6028 AOC2 ROM error No
6029 AOC2 CH2 command error No
6030 AOC2 sample vial is not set No
6031 AOC2 RAM error No
6032 AOC2 installation error No
6033 AOC2 CH1 error No
6034 AOC2 CH2 error No
6035 AOC2 waste vial is not set No

Shimadzu GC-2014 Specifications

General

Type	Gas Chromatograph
Display	LCD
Maximum Heating Rate	120°C/min
Data Acquisition	Digital
Maximum Number of Detectors	4
Weight	Approx. 45 kg
Carrier Gas	Helium, Nitrogen, Hydrogen
Detector Options	FID, TCD, ECD, FPD
Injection Port	Split/Splitless, On-column
Gas Control	Electronic Flow Control (EFC)
Temperature Programming Rate	0.1 to 120 °C/min
Power Requirements	230 V AC, 50/60 Hz
Detector Temperature Range	Up to 400°C (depending on detector type)