Shimadzu GC-2014 Instruction Manual

16 Special Functions
16.1 Time Scheduler
217
GC-2014
16.1.11 Starting/stopping a time schedule
Select “3. START/STOP” from the time scheduler menu when no time schedule is executing
to display the screen shown in Fig. 16.1.6.
Select “3. START/STOP” while a time schedule is executing to display the screen shown in
Fig. 16.1.7.
16.1.12 PF menu
Fig. 16.1.6 Schedule start screen Fig. 16.1.7 Schedule stop screen
PF menu Description
Reference
section
Start
Starts a time schedule.
This item is displayed when no time schedule is running.
If mode is set to “number”, the same schedule will be executed on
following day and beyond when schedule finishes.
If mode is set to “day”, the schedule for the current day is executed, and
the schedule for each day will be executed on the following day and
beyond.
――
Next
Runs the selected schedule on the following day.
If mode is set to “day”, the schedule for the next day is executed.
――
Stop
Stops the current schedule.
This item is displayed when a time schedule is running.
――

Shimadzu GC-2014 Specifications

General

Type	Gas Chromatograph
Display	LCD
Maximum Heating Rate	120°C/min
Data Acquisition	Digital
Maximum Number of Detectors	4
Weight	Approx. 45 kg
Carrier Gas	Helium, Nitrogen, Hydrogen
Detector Options	FID, TCD, ECD, FPD
Injection Port	Split/Splitless, On-column
Gas Control	Electronic Flow Control (EFC)
Temperature Programming Rate	0.1 to 120 °C/min
Power Requirements	230 V AC, 50/60 Hz
Detector Temperature Range	Up to 400°C (depending on detector type)