Shimadzu GC-2014 Instruction Manual

16 Special Functions
16.2 Batch Schedule
220
GC-2014
16.2.2 Parameter list
Vial Initial No. and final vial No.
Example: 1-9 (Analysis starts from vial No. 1 and ends at vial No. 9.)
GC GC method file for analyses
DP Channel No. of chromatopac and file No.
Example: 1-5 (Channel 1 and data processing file No. 5 are used.)
This setting is ignored when using GC solution software.
#INJ Number of times to inject
Mk “U” is displayed when “SAMPLE TYPE” is set to “Unknown”.
“S” is displayed when “SAMPLE TYPE” is set to “Standard”.
CMD “S” is displayed when “SLOPE TEST” is set to “On”.
“C” is displayed when “CLEAN UP” is set to “On”.
16.2.3 PF menu
PF menu Description
Reference
section
Start Starts the batch schedule.
――
Stop Stops the batch schedule.
――
New Creates a new batch schedule.
16.2.4
16.2.7
Del line Deletes the line at the current cursor position.
――
Print Prints the schedule to a Chromatopac.
――

Shimadzu GC-2014 Specifications

General

Type	Gas Chromatograph
Display	LCD
Maximum Heating Rate	120°C/min
Data Acquisition	Digital
Maximum Number of Detectors	4
Weight	Approx. 45 kg
Carrier Gas	Helium, Nitrogen, Hydrogen
Detector Options	FID, TCD, ECD, FPD
Injection Port	Split/Splitless, On-column
Gas Control	Electronic Flow Control (EFC)
Temperature Programming Rate	0.1 to 120 °C/min
Power Requirements	230 V AC, 50/60 Hz
Detector Temperature Range	Up to 400°C (depending on detector type)