Shimadzu GC-2014 Instruction Manual

15 Optional Devices
15.1 Auto Injector Parameters
197
GC-2014
15.1.3 PF menu
PF menu Description
Reference
section
Start Starts AOC. The GC also starts when AOC injects a sample.
――
Stop
Temporarily stops the AOC.
If [Start] (PF menu) is pressed in stop status, the AOC resumes the opera-
tion before [Stop] (PF menu) was pressed.
――
Priority Sets up a Priority analysis. 15.1.4
Other Para Sets AOC options and customization. 15.1.7
Sampler Sets the auto sampler, sub injector and bar code reader. 15.1.10
Reset Resets AOC to the status before control was started.
――
Upload
Loads parameters from the AOC to the AOC setup screen of the gas
chromatograph.
――
Print Prints the parameters on the Chromatopac.
――
Next
Toggles the screen among AOC parameters → AUX temperature → AUX
APC → AUX AMC → CRG screens in this order.
――

Shimadzu GC-2014 Specifications

General

Type	Gas Chromatograph
Display	LCD
Maximum Heating Rate	120°C/min
Data Acquisition	Digital
Maximum Number of Detectors	4
Weight	Approx. 45 kg
Carrier Gas	Helium, Nitrogen, Hydrogen
Detector Options	FID, TCD, ECD, FPD
Injection Port	Split/Splitless, On-column
Gas Control	Electronic Flow Control (EFC)
Temperature Programming Rate	0.1 to 120 °C/min
Power Requirements	230 V AC, 50/60 Hz
Detector Temperature Range	Up to 400°C (depending on detector type)