Shimadzu GC-2014 Instruction Manual

16 Special Functions
16.6 GC Configuration
240
GC-2014
AIR
Selection: Yes/No, Default: Yes
Indicate which detector APC zones should be included in the check.
The displayed items depend on the detector type.
AUX APC
APC1−APC15 PRESS
Selection: Yes/No, Default: Yes
This item is available only when optional APC units are installed.
AUX AMC
AMC1−AMC10 FLOW
Selection: Yes/No, Default: Yes
This item is available only when optional AMC units are installed.
DETECTOR
CONTROLLER
Selection: Yes/No, Default: Yes
This item is available only when the FID is installed.
DRIFT
Selection: Yes/No, Default: Yes
This item compares the baseline drift to the drift limit for 10 minutes.
Once the GC becomes ready, the GC re-evaluates of the ready status 10 minutes later.
WAIT SIGNAL
Selection: Yes/No, Default: Yes
The wait signal applies to all detectors configured in analytical lines.
User-specified names are used in this screen.
16.6.6.3 PF menu
PF menu Description
Reference
section
Drift Set the baseline drift limit.
――
NOTE

Shimadzu GC-2014 Specifications

General

Type	Gas Chromatograph
Display	LCD
Maximum Heating Rate	120°C/min
Data Acquisition	Digital
Maximum Number of Detectors	4
Weight	Approx. 45 kg
Carrier Gas	Helium, Nitrogen, Hydrogen
Detector Options	FID, TCD, ECD, FPD
Injection Port	Split/Splitless, On-column
Gas Control	Electronic Flow Control (EFC)
Temperature Programming Rate	0.1 to 120 °C/min
Power Requirements	230 V AC, 50/60 Hz
Detector Temperature Range	Up to 400°C (depending on detector type)