Shimadzu GC-2014 Instruction Manual

18 Error Messages
18.1 Error Messages
302
GC-2014
These messages appear when the detector (FID, FPD) cannot be ignited. Check the
detector’s line configuration and set detector control and temperature control to “On” before
ignition.
Code Message CS
9020 Temperature is not controlled No
9021 Detector is not controlled No
9022 FID/FPD is not installed No

Shimadzu GC-2014 Specifications

General

Type	Gas Chromatograph
Display	LCD
Maximum Heating Rate	120°C/min
Data Acquisition	Digital
Maximum Number of Detectors	4
Weight	Approx. 45 kg
Carrier Gas	Helium, Nitrogen, Hydrogen
Detector Options	FID, TCD, ECD, FPD
Injection Port	Split/Splitless, On-column
Gas Control	Electronic Flow Control (EFC)
Temperature Programming Rate	0.1 to 120 °C/min
Power Requirements	230 V AC, 50/60 Hz
Detector Temperature Range	Up to 400°C (depending on detector type)