Shimadzu GC-2014 Instruction Manual

3 Installing Packed Columns and Setting Analytical Flow Lines
3.2 Dual-Column Packed FID Analysis
35
GC-2014
3. Set the dual FID.
(1) Press the [DET] key.
(2) Set “Control mode” to “Dual.”
(3) Set “Signal polarity” as described below.
: The FID (L) - FID (R) signal is outputted.
(When a sample is injected into the dual INJ (L))
: The FID (R) - FID (L) signal is outputted.
(When a sample is injected into the dual INJ (R))
+
-

Shimadzu GC-2014 Specifications

General

Type	Gas Chromatograph
Display	LCD
Maximum Heating Rate	120°C/min
Data Acquisition	Digital
Maximum Number of Detectors	4
Weight	Approx. 45 kg
Carrier Gas	Helium, Nitrogen, Hydrogen
Detector Options	FID, TCD, ECD, FPD
Injection Port	Split/Splitless, On-column
Gas Control	Electronic Flow Control (EFC)
Temperature Programming Rate	0.1 to 120 °C/min
Power Requirements	230 V AC, 50/60 Hz
Detector Temperature Range	Up to 400°C (depending on detector type)