S
AVING
OR
R
ESTORING
C
ONFIGURATION
S
ETTINGS
4-33
- running-config to startup-config – Copies the running config to the
startup config.
- running-config to tftp – Copies the running configuration to a TFTP
server.
- startup-config to file – Copies the startup configuration to a file on the
switch.
- startup-config to running-config – Copies the startup config to the
running config.
- startup-config to tftp – Copies the startup configuration to a TFTP
server.
- tftp to file – Copies a file from a TFTP server to the switch.
- tftp to running-config – Copies a file from a TFTP server to the
running config.
- tftp to startup-config – Copies a file from a TFTP server to the startup
config.
- file to unit – Copies a file from this switch to another unit in the stack.
- unit to file – Copies a file from another unit in the stack to this switch.
• TFTP Server IP Address – The IP address of a TFTP server.
• File Type – Specify config (configuration) to copy configuration
settings.
• File Name — The configuration file name should not contain slashes
(\ or /), the leading letter of the file name should not be a period (.), and
the maximum length for file names on the TFTP server is 127 characters
or 31 characters for files on the switch. (Valid characters: A-Z, a-z, 0-9,
“.”, “-”, “_”)
• Source/Destination Unit – Stack unit. (Range: 1 - 8)
Note: The maximum number of user-defined configuration files is
limited only by available flash memory space.
To Next Page
General
