C
ONNECTING
TO
THE
S
WITCH
2-2
The switch’s web interface, CLI configuration program, and SNMP agent
allow you to perform the following management functions:
• Set user names and passwords
• Set an IP interface for any VLAN
• Configure SNMP parameters
• Enable/disable any port
• Set the speed/duplex mode for any port
• Configure the bandwidth of any port by limiting input or output rates
• Control port access through IEEE 802.1X security or static address
filtering
• Filter packets using Access Control Lists (ACLs)
• Configure up to 255 IEEE 802.1Q VLANs
• Enable GVRP automatic VLAN registration
• Configure IP routing for unicast traffic
• Configure IGMP multicast filtering
• Upload and download system firmware via TFTP
• Upload and download switch configuration files via TFTP
• Configure Spanning Tree parameters
• Configure Class of Service (CoS) priority queuing
• Configure up to 6 static or LACP trunks per switch, up to 32 per stack
• Enable port mirroring
• Set broadcast storm control on any port
• Display system information and statistics
• Configure any stack unit through the same IP address
To Next Page
Loading...
