U
SER
A
UTHENTICATION
C
OMMANDS
22-36
• You can also manually add secure addresses with the
mac-address-table static command.
• A secure port has the following restrictions:
- Cannot be connected to a network interconnection device.
- Cannot be a trunk port.
• If a port is disabled due to a security violation, it must be manually
re-enabled using the no shutdown command.
Example
The following example enables port security for port 5, and sets the
response to a security violation to issue a trap message:
Related Commands
shutdown (24-9)
mac-address-table static (28-2)
Console(config)#interface ethernet 1/5
Console(config-if)#port security action trap
To Next Page
Loading...
