30-1
C
HAPTER
30
VLAN C
OMMANDS
A VLAN is a group of ports that can be located anywhere in the network,
but communicate as though they belong to the same physical segment.
This section describes commands used to create VLAN groups, add port
members, specify how VLAN tagging is used, and enable automatic
VLAN registration for the selected interface.
Table 30-1 VLAN Commands
Command Groups Function Page
GVRP and
Bridge Extension
Configures GVRP settings that permit automatic
VLAN learning; shows the configuration for
bridge extension MIB
30-2
Editing VLAN Groups Sets up VLAN groups, including name, VID and
state
30-7
Configuring VLAN
Interfaces
Configures VLAN interface parameters,
including ingress and egress tagging mode,
ingress filtering, PVID, and GVRP
30-9
Displaying VLAN
Information
Displays VLAN groups, status, port members,
and MAC addresses
30-16
Configuring Private
VLANs
Configures private VLANs, including uplink and
downlink ports
30-17
Configuring Protocol
VLANs
Configures protocol-based VLANs based on
frame type and protocol
30-19
To Next Page
Loading...
