IP I
NTERFACE
C
OMMANDS
36-42
Command Mode
Interface Configuration (VLAN)
Command Usage
• When a non-default value is configured, the specified interval is used
both for router advertisements and by the router itself.
• This command specifies the interval between transmitting neighbor
solicitation messages when resolving an address, or when probing
the reachability of a neighbor. Therefore, avoid using very short
intervals for normal IPv6 operations.
Example
The following sets the interval between sending neighbor solicitation
messages to 30000 milliseconds:
Related Commands
show running-config (20-6)
Console(config)#interface vlan 1
Console(config)#pv6 nd ns-interval 30000
Console(config)#end
Console#show ipv6 interface
Vlan 1 is up
IPv6 is enable.
Link-local address:
FE80::200:E8FF:FE90:0/64
Global unicast address(es):
2009:DB9:2229::79, subnet is 2009:DB9:2229:0::/64
Joined group address(es):
FF01::1/16
FF02::1/16
FF02::1:FF00:79/104
FF02::1:FF90:0/104
MTU is 1500 bytes.
ND DAD is enabled, number of DAD attempts: 5.
ND retransmit interval is 1000 milliseconds
ND router advertisements are sent every 200 seconds
Console#
To Next Page
Loading...
Need help?
General
