IP R
OUTING
C
OMMANDS
37-18
Default Setting
The default depends on the setting specified with the version
command:
• Global RIPv1 - Route information is broadcast to other routers
with RIPv2
• Global RIPv2 - RIPv2 packets
Command Usage
• Use this command to override the global setting specified by the RIP
redistribute command.
• You can specify the receive version based on these options:
- Use “none” to passively monitor route information advertised by
other routers attached to the network.
- Use “1” or “2” if all routers in the local network are based on RIPv1
or RIPv2, respectively.
- Use “v2-broadcast” to propagate route information by
broadcasting to other routers on the network using RIPv2, instead
of multicasting as normally required by RIPv2. (Using this mode
allows RIPv1 routers to receive these protocol messages, but still
allows RIPv2 routers to receive the additional information provided
by RIPv2, including subnet mask, next hop and authentication
information.)
Example
This example sets the interface version for VLAN 1 to send RIPv1
packets.
Related Commands
redistribute (37-15)
Console(config)#interface vlan 1
Console(config-if)#ip rip send version 1
Console(config-if)#
To Next Page
Loading...
Need help?
General
