S
ETTING
THE
S
WITCH
’
S
IP A
DDRESS
(IP V
ERSION
4)
4-9
Command Attributes
• VLAN – ID of the configured VLAN (1-4093). By default, all ports on
the stack are members of VLAN 1. However, the management station
can be attached to a port belonging to any VLAN, as long as that VLAN
has been assigned an IP address.
• IP Address Mode – Specifies whether IP functionality is enabled via
manual configuration (Static), Dynamic Host Configuration Protocol
(DHCP), or Boot Protocol (BOOTP). If DHCP/BOOTP is enabled, IP
will not function until a reply has been received from the server.
Requests will be broadcast periodically by the switch for an IP address.
(DHCP/BOOTP values can include the IP address, subnet mask, and
default gateway.)
• IP Address – Address of the VLAN to which the management station
is attached. (Note that you can manage the stack through any configured
IP interface.) Valid IP addresses consist of four numbers, 0 to 255,
separated by periods. (Default: 0.0.0.0)
• Subnet Mask – This mask identifies the host address bits used for
routing to specific subnets. (Default: 255.0.0.0)
• Gateway IP Address – IP address of the gateway router between the
stack and management stations that exist on other network segments.
(Default: 0.0.0.0)
• MAC Address – The physical layer address for this switch.
To Next Page
Loading...
