Studer Vista - Page 612

STUDER 07. Mar. 2005 Release Notes Vista 3.5
5/21
MIDI
It is possible to use MIDI note, program change and controller messages both as a source for firing a
cue or as events to be sent out of the console upon recalling a cue. In order to attach a MIDI
command as cue trigger, drag&drop the MIDI icon to the left side of the cue name. If a MIDI
command should be sent out upon cue recall, drag&drop the MIDI icon to the right side of the cue.
It is possible to add multiple output events to the cue.
Event options
After having attached an event to a cue, it is possible to alter various parameters, depending on the
event. After having attached an event to a cue, click on the event icon within the cue list. The
corresponding options are displayed within the "Options" area of the window (bottom left). The
following options are available:
- MIDI In: Program, note change and controller commands may activate the corresponding cue
- MIDI Out: Program change, note change, controller and sysex commands may be fired off by
this event. A TEST button allows sending out this parameter during system setup without
recalling the cue.
- Blackout: Console lights On/Off.
- Notes: Enter your notes. An option allows the user to change the behaviour of the cue list
for note events: Should they be displayed before the cue is recalled or afterwards? (see
“Options” for more details.)
- HiQNet: "Venue Recall" message sent out of the console to any HiQNet device. The
corresponding venue number is entered in the configuration area of the window.