STUDER 07. Mar. 2005 Release Notes Vista 3.5
19/21
Targets with their respective connections can be selected by clicking on them in the list on the
general patch. Selected targets change their colour to pink to show their selection state.
Hitting the “Map Currently Selected” button maps the patches for the selected targets (the pink
coloured ones) to the Pro-Bel connect command specified on the left.
With the listen button enabled, incoming connect messages are mapped to the edit fields on the
dialog. To select targets affected by this connect command simply click on them in the target list of
the general patch (colour is set to pink).
Make sure to always associate the same Pro-Bel destination to the same set of targets.
It is possible to map any connection on the patch to certain Pro-Bel connect commands. You are not
limited to outputs or inputs!
It's possible to activate spontaneous messages. The appropriate CONNECTED message is sent
whenever one of the defined patch combinations matches the combination when they were defined.
To Next Page
Loading...
