Vista Digital Mixing System
10 Software V4.1 SW V4.1 Date printed: 20.08.09
# The containerid identifies this container
# and must be unique within the mixing console system
# This id is fixed to ‹10› (CORE) for all VISTA desks
containerid = 20 ‚20’ is always standing when the container.ini is belonging to a configtool
# The containername identifies this container in a readable way
# and must be unique within the mixing console system. It is recommended
# not to use more than 8 characters due to visualization aspects.
# «Undefined» is not allowed!
containername = «Config»
the name of the container
# Multicast
# -----------
# If you use IGMP multicasts instead of broadcasts in your network,
# you have to uncomment the lines below. It is possible that a
# container is member of one or more than one multicast groups.
#
# NOTE: For an optimal performance, make sure that all network resources
# (Switches, Routers...) support IGMP.
#
# NOTE: To avoid IP conflicts, check the available addresses for
# multicast groups (www.iana.org). Use preferable addresses from the
# local scope (239.255.0.0/16) described in RFC 2365.
#
# NOTE: If the multicast should reach computers beyond the local subnet
# Set MulticastTimeToLive > 1 (1 is default)
# MulticastGroup = 239.255.0.1
# MulticastGroup = 239.255.0.2
# MulticastGroup = 239.255.0.3
# MulticastTimeToLive = 10
# Multiple Network Adapters
# ---------------------------------
# When more than one network adapter is enabled on the computer, the MAC Address has to be specified
#
# MAC = 00-1A-A0-B9-F9-88
Note: There needs to be a second container.ini file on the Vista’s control com-
puter – the one which is belonging to the mixing console application (see
chapter 7.1.4).
To Next Page
Loading...
