Vanderbilt SPC53 Series User Manual

Engineer programming via the browser
17
Configuring Communications
283
Vanderbilt
Installation & Configuration Manual
A6V10276959
01.05.2016
ATP Sequence No.
This field displays the sequence number of the
ATP in the ATS configuration. Number 1 is
primary, numbers 2 - 10 are backup
ATP Unique ID
This ID uniquely identifies the ATP to the RCT
ATP Name
Enter a name for the ATP
SPT Account Code
Enter a number to uniquely identify the panel to
the RCT (1 - 999999)
ARC Connection
Number 1
Phone number 1
Number 2
Phone number 2
Modem Select
Select the modem to be used.
 Modem 1
 Modem 2
Test Calls
Test Call Mode (Non-active ATP)
Select the mode for sending test calls when the
ATP is in non-active mode. Default: 24 hours.
 Test calls disabled
 Test call every 10 minutes
 Test call every 1 hour
 Test call every 24 hours
 Test call every 48 hours
 Test call every 7 days
 Test call every 30 days.
Test Call Mode (Active ATP)
Select the mode for sending test calls when the
ATP is an active ATP. Default: 24 hours.
 Test calls disabled
 Test call every 10 minutes
 Test call every 1 hour
 Test call every 24 hours
 Test call every 48 hours
 Test call every 7 days
 Test call every 30 days.
Time of first test call
Time of first test call after reset or ATS
initialization.
 Send Immediately (default)
 or
 Select a half hour interval between 00:00 and
23:30
Event Protocol
Protocol
Protocol used in communication.
 SIA
 SIA Extended 1
 SIA Extended 2
 Contact ID
Event Profile
Select the Event Profile which defines how and
which events are transmitted on this ATS.
 Use ATS Setting
 Default Event Profile
 Default Portal Event Profile
 All events
 Custom Event Profile
ATP Faults
ATP Monitoring Fault
Select to generate an ATP fault if the ATP

Vanderbilt SPC53 Series Specifications

General

Brand	Vanderbilt
Model	SPC53 Series
Category	Power Supply
Language	English