Engineer programming via the browser
Configuring Communications
Installation & Configuration Manual
If an IP connection is required, ensure the Ethernet interface is correctly configured
(see page [➙ 159]) and that internet access is enabled at the router.
Adding an EDP Receiver
1. Select Communications > Reporting > EDP.
The following window will be displayed:
Max. 8 receivers can be added to the SPC system.
2. Click on the Add button.
The following window will be displayed.
3. See table below for further information.
Enter a text description of the receiver.
Enter a unique number which will be used by the EDP to identify the receiver.
See also
Editing EDP Receiver Settings [➙ 296]
Editing EDP Receiver Settings
1. Select Communications > Reporting > EDP > Edit.
The following window will be displayed.
2. Configure the fields as described in the table below.