Xerox Phaser 790

10/00
5-32
Phaser 790/DocuColor 2006
PL 8.3
Initial Issue
Parts List
PL 8.3 Fusing (3 of 7)
Item Part Description
1 – Heater Wire (P/O PL 8.2 Item 1)
2 – Fuser Front Frame (P/O PL 8.2
Item 1)
3 – Fuser Rear Frame (P/O PL 8.2 Item
1)
4 059K15010 Pressure Roll (REP 10.11 ADJ
10.1)
5 013E87470 Bearing (2/Kit) (ADJ 10.1)
6 – Fuser Entry Plate (P/O PL 8.2 Item
1)
7 059K15030 Heat Roll (ADJ 10.1)
8 – Fuser Nip Bearing (P/O PL 8.2 Item
1)
9 – Gear (P/O PL 8.2 Item 20)
10 – Ring (P/O PL 8.2 Item 20) (2/Kit)
11 007E58991 Gear
12 007E60321 Gear
13 126K11330 Heat Roll Heat Lamp 220v (REP
10.5 ADJ 10.1)
– 126K11290 Heat Roll Heat Lamp 110v (REP
10.5 ADJ 10.1)
14 126K11340 Pressure Roll Heat Lamp 220v
(REP 10.6 ADJ 10.1)
– 126K11300 Pressure Roll Heat Lamp 110v
(REP 10.6 ADJ 10.1)
15 – Fuser Baffle (P/O PL 8.2 Item 1)
16 – Tie Bracket (P/O PL 8.2 Item 1)
17 – Shaft (P/O PL 8.2 Item 1)
18 – Front Cam (P/O PL 8.2 Item 1)
19 – Rear Cam (P/O PL 8.2 Item 1)
20 600K85480 Heat Roll Hardware Kit (REP 10.10
ADJ 10.1)