Standards Compliance
5
5.2 European Standards
YASKAWA SIEPC71061705H GA700 Series Technical Manual 217
The following conditions must be satisfied for machines and devices incorporating this product to comply with
the CE Low Voltage Directive.
■ Area of Use
Install this product in a location with Overvoltage Category III and pollution degree 2 or less as specified in IEC/
CE 60664.
■ Guarding Against Debris
When you install IP20/UL Open type drives (models: 2xxxxB, 4xxxxB), use an enclosure panel that does not let
unwanted material enter the drive from above or below.
■ Electrical Installation
Refer to Figure 5.2 for an example of a drive that is wired to comply with the CE Low Voltage Directive.