YASKAWA GA700 Series

Parameter Details
12
12.8 H: Terminal Functions
YASKAWA SIEPC71061705H GA700 Series Technical Manual 845
Table 12.69 MFAI Setting Values
Setting
Value
Function Ref.
0 Frequency Reference 851
1 Frequency Gain 851
2 Auxiliary Frequency Reference 1 851
3 Auxiliary Frequency Reference 2 851
4 Output Voltage Bias 852
5 Accel/Decel Time Gain 852
6 DC Injection Braking Current 852
7 Torque Detection Level 853
8 Stall Prevent Level During Run 853
9 Output Frequency Lower Limit 853
B PID Feedback 853
C PID Setpoint 854
D Frequency Bias 854
Setting
Value
Function Ref.
E Motor Temperature (PTC Input) 854
F Not Used 854
10 Forward Torque Limit 854
11 Reverse Torque Limit 855
12 Regenerative Torque Limit 855
13 Torque Reference / Torque Limit 856
14 Torque Compensation 856
15 General Torque Limit 856
16 Differential PID Feedback 856
1F Not Used 856
30 DWEZ Analog Input 1 856
31 DWEZ Analog Input 2 856
32 DWEZ Analog Input 3 856
Note:
All analog input scaling uses gain and bias for adjustment. Set the gain and bias values correctly.
Example
Analog Input
Settings
Setting of Terminal A1 Frequency Reference
Frequency
reference with the
gain setting
adjusted
• H3-02 = 0 [Terminal A1 Function
Selection = Frequency Reference]
• H3-03: 200.0 [Terminal A1 Gain
Setting = 200%]
• H3-04 = 0.0 [Terminal A1 Bias
Setting = 0.0%]
• When you input a 10 V signal, the frequency reference will be 200%.
• When you input a 5 V signal, the frequency reference will be 100%.
When you input a 5 Vor more signal, E1-04 [Maximum Output Frequency] will limit the drive output and the
frequency reference will be 100%.
Frequency
reference with the
negative number
bias set
• H3-02 = 0 [Frequency Reference]
• H3-03 = 100.0 [100.0%]
• H3-04 = -25.0 [-25.0%]
• When you input a 0 V signal, the frequency reference will be -25%.
• When H3-01 = 0 [Terminal A1 Signal Level Select = 0 to 10V (Lower Limit at 0)]:
– When you input a 0 V to 2 V signal, the frequency reference will be 0%.
– When you input a 2 V to 10 V signal, the frequency reference will be 0% to 100%.
• When H3-01 = 1 [-10 to +10V (Bipolar Reference)]:
– When you input a 0 V to 2 V signal, it enables signals of positive and negative polarities and the motor
rotates in reverse.