Docu ment No. E ZZ024048<1>
Pr epared in October, 2021
6 / 19
◼ Se t the Sampling Time for a Trend Log
The procedure in this section shows how to set the sampling time for a trend log. When a
trend log is set, it works concurrently with the short-term data log to save the data before
the trigger is detected.
Note: This setting is displayed only when short-term data log is selected for the data log
type.
1. Push (Home) to show the HOME screen.
Note: When the drive is in HOME Mode, the screen shows [Home] in the upper right-
hand corner of the screen.
If the screen does not show [Home] for , push (Back), and then push
to show [Home].
2. Push (Menu).
3. Push or to select [Diagnostic Tools], then push .
4. Push or to select [Data Logger], then push (Setup).
5. Push or to select [Trend Log Sampling Selection], then push .
6. Push or to select the sampling time for the trend log, then push .
The procedure to set the sampling time for the trend log is complete.
To Next Page
Loading...
