EasyManuals Logo

Allied Telesis AT-GS900M Series User Manual

Allied Telesis AT-GS900M Series
542 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #110 background imageLoading...
Page #110 background image
Chapter 6: Log Commands
110 Section II: Switch Management
SHOW LOG STATUS
Syntax
show log status
Parameters
None
Description
Use this command to display the log status:
An example of the command output is shown in Figure 16.
Figure 16. SHOW LOG STATUS Command
Example
The following command displays the log status:
Manager> show log status
Log System Status
--------------------------------------------
Log Module Status .............. Enabled
Log Message Generation ......... Enabled
Permanent Output ............... Enabled
Syslog Output .................. Disabled
Next Message ID ................ 3008
Number of Output Definitions ... 2
--------------------------------------------

Table of Contents

Other manuals for Allied Telesis AT-GS900M Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AT-GS900M Series and is the answer not in the manual?

Allied Telesis AT-GS900M Series Specifications

General IconGeneral
BrandAllied Telesis
ModelAT-GS900M Series
CategorySwitch
LanguageEnglish

Related product manuals