Chapter 21: Multiple Spanning Tree Protocol (MSTP) Commands
384 Section III: Layer 2 Switching
DISABLE MSTP DEBUG MSTI
Syntax
disable mstp debug=msg|pkt|state|all msti=cist|
instance
|all
[port=
port_list
|all]
Parameters
debug
Specifies a debug option to disable.
msg
Specifies the msg option to decode and display BPDU.
pkt
Specifies the pkt option to display BPDU for an ASCII value.
state
Specifies the state option to display the state of ports.
msti
Specifies an MST instance that the debug option is disabled for.
csti
Common and Internal Spanning Tree (CIST) instance.
instance
Specifies MST instance ID. The range is 1 to 15.
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
Description
This command is used to disable the debug option on the specified MSTP
instance. By default, MSTP debugging is disabled.
Confirmation Command
“SHOW MSTP DEBUG MSTI” on page 402
Examples
The following command disables all MSTP debug options on all MSTP
instances:
disable mstp debug=all msti=all
To Next Page
Loading...
