Chapter 7: SNMP Commands
124 Section II: Switch Management
DISABLE SNMP TRAP
Syntax
disable snmp trap=
trap
Parameters
trap
Specifies a trap type or multiple trap types. To specify multiple trap
types, use a comma (,). To specify all trap types, use the keyword
all. For a list of trap types, see “CREATE SNMP COMMUNITY” on
page 115.
Description
Use this command to disable generating the specified trap type. By
default, generating traps is disabled.
Confirmation Command
“SHOW SNMP TRAP” on page 142
Example
The following command disables generating the coldstart traps:
Manager > disable snmp trap=coldstart
To Next Page
Loading...
