Chapter 5: Basic Operations Commands
86 Section I: Getting Started
SHOW FILE
Syntax
show file[=
file_name
]
Parameter
file_name
Specifies the file name of a file to display its content. You can also
specify a file name using one wild card (*). The wild card (*) must
be at the beginning or end of the file name.
Description
Use this command to display a list of the files stored on the switch or the
content of the specified file. You can specify only a configuration file (.cfg)
or script file (.scp).
Figure 7 shows an output example to display a list of files stored on the
switch.
Figure 7. SHOW FILE Command
Figure 8 on page 87 shows an output example to display the content of the
specified configuration file.
Manager > show file
Filename Device Size Created Attribute
----------------------------------------------------------------------------
config1.cfg flash 2525 2011-04-21 15:55:40 script
config2.cfg flash 897 2011-05-18 17:38:09 script
gs900mv2_v232.rel flash 7159743 2011-04-25 16:08:03 relpkg
----------------------------------------------------------------------------
Available Blocks: 5 (about 1 block = 128kB)
To Next Page
Loading...
