Chapter 27: Port-Based Authentication Commands
518 Section IV: Security and Traffic Control
SET PORTAUTH PORT (802.1X Authenticator Port)
Syntax
set portauth[=8021x] port=
port_list
|all type=authenticator
[mode=single|multi] [control=authorised|unauthorised|auto]
[eapolversion=1|2] [servertimeout=
servertimeout
]
[quietperiod=
quietperiod
] [txperiod=
txperiod
]
[reauthperiod=
reauthperiod
] [supptimeout=
timeout
]
[maxreq=
maxreq
] [reauthenabled=enabled|disabled]
[piggyback=enabled|disabled] [guestvlan=
vlan_name
|
vid
|none]
[securevlan=on|off] [vlanassignment=enabled|disabled]
[vlanassignmenttype=user|port]
Parameters
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
mode
Specifies the mode of an authenticator port that is connected to
single or multiple supplicants.
single
When the port is connected to one supplicant device.
multi
When the port is connected to multiple supplicant devices.
control
Specifies the state of the authenticator port.
auto
The state of the authenticator port is based on the result of the
authentication. This is the default setting.
authorised
The state of the authenticator port is fixed to be authorized.
unauthorised
The state of the authenticator port is fixed to be unauthorized.
eapolversion
Specifies the EAPOL version on the 802.1x authenticator port.
To Next Page
Loading...
Need help?
General
