Allied Telesis AT-GS900M Series - Enable Switch Port

AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 243
ENABLE SWITCH PORT
Syntax
enable switch port= port_list |all
Parameters
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies all the switch ports.
Description
Use this command to enable switch ports.
Confirmation Command
“SHOW SWITCH PORT” on page 272
Example
The following command enables port 5 to port 10.
Manager > enable switch port=5-10