EasyManuals Logo

Allied Telesis AT-GS900M Series User Manual

Allied Telesis AT-GS900M Series
542 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #266 background imageLoading...
Page #266 background image
Chapter 14: Switching Commands
266 Section III: Layer 2 Switching
SET SWITCH TRUNK
Syntax
set switch trunk=
trunk_name
speed=1000m|100m|10m
Parameters
trunk_name
Specifies a trunk name.
speed
Specifies port speed.
1000m
The port is set to 1000M speed, the full duplex, and Auto-
negotiation. Combo ports must be set to 1000m. This is the default
setting.
100m
The port is set to 100M speed, the full duplex, and Auto-
negotiation.
10m
The port is set to 10M speed, the full duplex, and Auto-negotiation.
Description
Use this command to change the trunk settings.
Confirmation Command
“SHOW SWITCH TRUNK” on page 278
Example
The following command changes the trunk name to uplink and the speed
to 1000m:
Manager > set switch trunk=uplink speed=1000m

Table of Contents

Other manuals for Allied Telesis AT-GS900M Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AT-GS900M Series and is the answer not in the manual?

Allied Telesis AT-GS900M Series Specifications

General IconGeneral
BrandAllied Telesis
ModelAT-GS900M Series
CategorySwitch
LanguageEnglish

Related product manuals