Allied Telesis AT-GS900M Series - Reset Switch Stormdetection Counter

AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 251
RESET SWITCH STORMDETECTION COUNTER
Syntax
reset switch stormdetection [port= port_list |all] counter
Parameters
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies all the switch ports. This is the default setting.
Description
Use this command to clear the counters of detecting the receiving rate.
Confirmation Command
“SHOW SWITCH STORMDETECTION” on page 276
Example
The following command clears the counters of detecting the receiving rate
on port 2:
Manager > reset switch stormdetection port=2 counter