Allied Telesis AT-GS900M Series - Disable Switch Eapforwarding

AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 229
DISABLE SWITCH EAPFORWARDING
Syntax
disable switch eapforwarding
Parameters
None
Description
Use this command to disable Extensible Authentication Protocol (EAP)
authentication. By default, EAP protection is disabled.
Note
When Port-based Authentication is enabled on the switch, EAP
cannot be enabled.
Confirmation Command
“SHOW SWITCH” on page 267
Example
The following command disables EAP authentication:
Manager > disable switch eapforwarding