Allied Telesis AT-GS900M Series User Manual

Chapter 11: RADIUS Authentication Server Commands
186 Section II: Switch Management
SET RADIUSACCOUNTING
Syntax
set radiusaccounting [status=enabled | disabled]
[serverport=
port_number ] [type=network]
[trigger=start_stop | stop_only]
[updateenable=enabled | disabled] [interval=
interval ]
Parameters
status
Specifies the RADIUS accounting server to be enabled or
disabled.
serverport
Specifies the UDP port for the RADIUS server for accounting. The
default setting is 1813. You must specify the same port number
that is specified by the ADD RADIUSSERVER SERVER
command.
type
Specifies the place to send accounting information. This is always
network.
trigger
Specifies when the RADIUS client sends accounting requests to
the RADIUS accounting server. The default setting is start_stop.
start_stop
Specifies that the RADIUS client sends accounting requests when
a supplicant logs in and logs out.
stop_only
Specifies that the RADIUS client sends accounting requests when
a supplicant logs out.
updateenable
Specifies that sending interim accounting messages to the
RADIUS accounting server is enabled or disabled. By default,
sending interim accounting messages is disabled.
interval
Specifies the interval in seconds of sending interim accounting
messages. The range is 30 to 300 seconds. The default setting is
60 seconds.

Allied Telesis AT-GS900M Series Specifications

General

Brand	Allied Telesis
Model	AT-GS900M Series
Category	Switch
Language	English