AT-GS900M Series CLI Reference
Section III: Layer 2 Switching 219
Chapter 14
Switching Commands
The Switching commands are summarized in Table 31.
Table 31. Switching Commands
Command Description
“ACTIVATE SWITCH PORT
AUTONEGOTIATE” on page 222
Enables Auto-negotiation to ports.
“ADD SWITCH TRUNK” on
page 223
Adds a list of ports to a trunk group.
“CREATE SWITCH TRUNK” on
page 224
Creates a trunk group.
“DELETE SWITCH TRUNK” on
page 226
Removes the ports from the trunk group.
“DESTROY SWITCH TRUNK” on
page 227
Deletes a trunk group.
“DISABLE SWITCH
BPDUFORWARDING” on
page 228
Disables Bridge Protocol Data Unit (BPDU)
protection.
“DISABLE SWITCH
EAPFORWARDING” on page 229
Disables Extensible Authentication Protocol
(EAP) authentication.
“DISABLE SWITCH
INFILTERING” on page 230
Disables the ingress filtering feature.
“DISABLE SWITCH
LOOPDETECTION” on page 231
Disables Loop Detection.
“DISABLE SWITCH MIRROR” on
page 232
Disables port mirroring.
“DISABLE SWITCH PORT” on
page 233
Disables switch ports.
“DISABLE SWITCH PORT
AUTOMDI” on page 234
Disables ports to automatically detect MDI or
MDI-X.
“DISABLE SWITCH PORT FLOW”
on page 235
Disables flow control on ports.
To Next Page
Loading...
