Allied Telesis AT-GS900M Series User Manual

AT-GS900M Series CLI Reference
Section I: Getting Started 85
SHOW CONFIG
Syntax
show config [dynamic= module_name ]|[all= module_name ]
Parameters
module_name
Specifies the module name such as vlan, ip, igmpsnooping,
mldsnooping, mac, trunk.
dynamic
Specifies the no file. When rebooting, the switch starts with the
default configuration.
all
Specifies no file. When rebooting, the switch starts with the default
configuration.
Description
Use this command to display the configuration settings assign the start-up
configuration file.
Example
The following command resets the switch to the default configuration:
Manager> show config=none
The following command assigns the config3.cfg file as the start-up
configuration file:
Manager> show config=config3.cfg

Allied Telesis AT-GS900M Series Specifications

General

Brand	Allied Telesis
Model	AT-GS900M Series
Category	Switch
Language	English