Allied Telesis AT-GS900M Series - Set Qos Hwqueue

Chapter 25: Quality of Service (QoS) Commands
448 Section IV: Security and Traffic Control
SET QOS HWQUEUE
Syntax
set qos hwqueue= queue weight= weight
Parameters
queue
Specifies a queue number. The range is 0 to 3.
weight
Specifies the weight ratio to the queue. See Table 54 for the
default settings.
Description
Use this command to change the weight ratio to the queue.
The default settings of the priority queue ratio is shown in Table 54.
Confirmation Command
“SHOW QOS HWQUEUE” on page 453
Example
The following command change the weight ratio on queue 0 to 2:
Manager > set qos hwqueue=0 weight=2
Table 54. Defaut Priority Queue Ratio
Queue Number Weight Ratio
01
14
210
315