Allied Telesis AT-GS900M Series - Show Qos Flowgroup

AT-GS900M Series Command Reference
Section IV: Security and Traffic Control 493
SHOW QOS FLOWGROUP
Syntax
show qos flowgroup[= flow_list |all]
Parameters
flowgroup
Specifies a list of flow groups. To specify multiple flow groups, use
a comma (,) to separate them. To specify a range of flow groups,
use a hyphen (-).
Description
Use this command to display the settings of flow groups. An example of
the command output is shown in Figure 72.
Figure 72. SHOW QOS FLOWGROUP Command
Example
The following example displays the settings of flow groups:
Manager > show qos flowgroup
---------------------------------------------
FlowGroup ID ................. 0
Description ..................
DSCP value ...................
Priority .....................
Remark Priority .............. No
Classifier List ..............
Parent Traffic Class ID ......
Is Active .................... No