Chapter 14: Switching Commands
272 Section III: Layer 2 Switching
SHOW SWITCH PORT
Syntax
show switch port[=
port_list
|all] [summary|security]
Parameters
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies all the switch ports.
summary
Displays the summary of port settings.
security
Displays security settings on ports.
Description
Use this command to display port settings and security settings. An
example of the command output is shown in Figure 39 on page 273.
To Next Page
Loading...
