Chapter 27: Port-Based Authentication Commands
532 Section IV: Security and Traffic Control
SHOW PORTAUTH
Syntax
show portauth[=8021x|macbased|webbased] [config|status]
Parameters
portauth
Specifies an authentication method to display the information
about. By default, the system displays information about all
authentication methods.
8021x
Specifies 802.1x Port-Based Authentication using EAP.
macbased
Specifies MAC-Based Authentication.
webbased
Specifies Web-based Authentication.
config
Displays the configuration information.
status
Displays the status.
Description
Use this command to display information about Port-Based
Authentication. An example of the command output is shown in Figure 76
on page 533.
To Next Page
Loading...
