Allied Telesis AT-GS900M Series - Set Qos Dscp

AT-GS900M Series CLI Reference
Section IV: Security and Traffic Control 445
SET QOS DSCP
Syntax
set qos dscp== dscp_list |all] priority= priority
Parameters
dscp_list
Specifies a list of the values of DiffServ Code Point (DSCP). To
specify multiple values, use a comma (,) to separate them. To
specify a range of values, use a hyphen (-).
all
Specifies all values from 0 to 63.
priority
Specifies a user priority. The range is 0 to 7. The default value is 0.
Description
Use this command to change the DSCP table.
Confirmation Command
“SHOW QOS DSCP” on page 451
Example
The following command changes the DSCP table to DSCP 0 to 3:
Manager > set qos dscp=0-3 priority=1