Chapter 27: Port-Based Authentication Commands
534 Section IV: Security and Traffic Control
SHOW PORTAUTH PORT AUTHENTICATOR
Syntax
show portauth[=8021x|macbased|webbased] port=
port_list
|all
[authenticator] [config|status]
Parameters
portauth
Specifies an authentication method to display the information
about. By default, the system displays information about all
authentication methods.
8021x
Specifies 802.1x Port-Based Authentication using EAP.
macbased
Specifies MAC-Based Authentication.
webbased
Specifies Web-based Authentication.
port_list
Specifies a list of ports. To specify multiple ports, use a comma (,)
to separate them. To specify a range of ports, use a hyphen (-).
all
Specifies all the switch ports.
authenticator
Displays information about the authenticator.
config
Displays the configuration information.
status
Displays the status.
Description
Use this command to display authenticator information about Port-Based
Authentication on the specified port. An example of the command output is
shown in Figure 77 on page 535.
To Next Page
Loading...
