Allied Telesis AT-GS900M Series - Chapter 24: Multicast Listener Discovery (MLD) Snooping Commands

AT-GS900M Series CLI Reference
Section IV: Security and Traffic Control 429
Chapter 24
Multicast Listener Discovery (MLD)
Snooping Commands
The MLD Snooping commands are summarized in Table 50.
Table 50. MLD Snooping Commands
Command Description
“ADD MLDSNOOPING
MCGROUP” on page 430
Adds an IPv6 multicast group for MLD
Snooping.
“DELETE MLDSNOOPING” on
page 432
Deletes a static IPv6 multicast group
address.
“DISABLE MLDSNOOPING” on
page 433
Disables MLD Snooping.
“ENABLE MLDSNOOPING” on
page 434
Enables MLD Snooping.
“SET MLDSNOOPING” on
page 435
Specifies the timeout and changes the
settings of the IPv6 multicast group.
“SET MLDSNOOPING
MCGROUP” on page 437
Changes the router ports for the IPv6
multcast group.
“SHOW MLDSNOOPING” on
page 439
Displays the settings and status of MLD
Snooping.