EasyManuals Logo

Allied Telesis AT-GS900M Series User Manual

Allied Telesis AT-GS900M Series
542 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #338 background imageLoading...
Page #338 background image
Chapter 18: Power Over Ethernet (PoE) Commands
338 Section III: Layer 2 Switching
SET POE MANAGEMENT
Syntax
set poe management[=class|actual]
Parameters
class
Specifies the class power management mode. The switch assigns
power to ports based on the class of the PD connected to the port.
actual
Specifies the actual power management mode. The switch assigns
power to ports based on power usage of the PD connected to the
port.
Description
Use this command to specify the power management mode to the switch.
Note
The PoE commands are available only for the GS908M V2-4PS
switch.
Confirmation Command
“SHOW POE” on page 342
Example
The following command specifies the switch to assign power to ports
based on the class of the PD connected to the port:
Manager > set poe management=class

Table of Contents

Other manuals for Allied Telesis AT-GS900M Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AT-GS900M Series and is the answer not in the manual?

Allied Telesis AT-GS900M Series Specifications

General IconGeneral
BrandAllied Telesis
ModelAT-GS900M Series
CategorySwitch
LanguageEnglish

Related product manuals